Viewing file:  altera-a10sr.h (3.42 KB) -rw-r--r--
Select action/file-type:
 (+) |  (+) |  (+) | Code (+) | Session (+) |  (+) | SDB (+) |  (+) |  (+) |  (+) |  (+) |  (+) |
/*
* Copyright Intel Corporation (C) 2014-2016. All Rights Reserved
*
* This program is free software; you can redistribute it and/or modify it
* under the terms and conditions of the GNU General Public License,
* version 2, as published by the Free Software Foundation.
*
* This program is distributed in the hope it will be useful, but WITHOUT
* ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or
* FITNESS FOR A PARTICULAR PURPOSE. See the GNU General Public License for
* more details.
*
* You should have received a copy of the GNU General Public License along with
* this program. If not, see <http://www.gnu.org/licenses/>.
*
* Declarations for Altera Arria10 MAX5 System Resource Chip
*
* Adapted from DA9052
*/
#ifndef __MFD_ALTERA_A10SR_H
#define __MFD_ALTERA_A10SR_H
#include <linux/completion.h>
#include <linux/list.h>
#include <linux/mfd/core.h>
#include <linux/regmap.h>
#include <linux/slab.h>
/* Write registers are always on even addresses */
#define WRITE_REG_MASK 0xFE
/* Odd registers are always on odd addresses */
#define READ_REG_MASK 0x01
#define ALTR_A10SR_BITS_PER_REGISTER 8
/*
* To find the correct register, we divide the input GPIO by
* the number of GPIO in each register. We then need to multiply
* by 2 because the reads are at odd addresses.
*/
#define ALTR_A10SR_REG_OFFSET(X) (((X) / ALTR_A10SR_BITS_PER_REGISTER) << 1)
#define ALTR_A10SR_REG_BIT(X) ((X) % ALTR_A10SR_BITS_PER_REGISTER)
#define ALTR_A10SR_REG_BIT_CHG(X, Y) ((X) << ALTR_A10SR_REG_BIT(Y))
#define ALTR_A10SR_REG_BIT_MASK(X) (1 << ALTR_A10SR_REG_BIT(X))
/* Arria10 System Controller Register Defines */
#define ALTR_A10SR_NOP 0x00 /* No Change */
#define ALTR_A10SR_VERSION_READ 0x00 /* MAX5 Version Read */
#define ALTR_A10SR_LED_REG 0x02 /* LED - Upper 4 bits */
/* LED register Bit Definitions */
#define ALTR_A10SR_LED_VALID_SHIFT 4 /* LED - Upper 4 bits valid */
#define ALTR_A10SR_OUT_VALID_RANGE_LO ALTR_A10SR_LED_VALID_SHIFT
#define ALTR_A10SR_OUT_VALID_RANGE_HI 7
#define ALTR_A10SR_PBDSW_REG 0x04 /* PB & DIP SW - Input only */
#define ALTR_A10SR_PBDSW_IRQ_REG 0x06 /* PB & DIP SW Flag Clear */
/* Pushbutton & DIP Switch Bit Definitions */
#define ALTR_A10SR_IN_VALID_RANGE_LO 8
#define ALTR_A10SR_IN_VALID_RANGE_HI 15
#define ALTR_A10SR_PWR_GOOD1_REG 0x08 /* Power Good1 Read */
#define ALTR_A10SR_PWR_GOOD2_REG 0x0A /* Power Good2 Read */
#define ALTR_A10SR_PWR_GOOD3_REG 0x0C /* Power Good3 Read */
#define ALTR_A10SR_FMCAB_REG 0x0E /* FMCA/B & PCIe Pwr Enable */
#define ALTR_A10SR_HPS_RST_REG 0x10 /* HPS Reset */
#define ALTR_A10SR_USB_QSPI_REG 0x12 /* USB, BQSPI, FILE Reset */
#define ALTR_A10SR_SFPA_REG 0x14 /* SFPA Control Reg */
#define ALTR_A10SR_SFPB_REG 0x16 /* SFPB Control Reg */
#define ALTR_A10SR_I2C_M_REG 0x18 /* I2C Master Select */
#define ALTR_A10SR_WARM_RST_REG 0x1A /* HPS Warm Reset */
#define ALTR_A10SR_WR_KEY_REG 0x1C /* HPS Warm Reset Key */
#define ALTR_A10SR_PMBUS_REG 0x1E /* HPS PM Bus */
/**
* struct altr_a10sr - Altera Max5 MFD device private data structure
* @dev: : this device
* @regmap: the regmap assigned to the parent device.
*/
struct altr_a10sr {
struct device *dev;
struct regmap *regmap;
};
#endif /* __MFD_ALTERA_A10SR_H */
|